Wheel sensitivity setup
Press PROG button, red LED will start to blink.
For high sensitivity, press on D-PAD.
For medium sensitivity, press on D-PAD.
For low sensitivity, press on D-PAD.
SWITCHING BETWEN X-INPUT AND
D-INPUT MODES
To switch between X-Input and D-Input modes while wheel is connected to PC,
press and hold MODE button for 3 seconds.
Red LED will solid lit after change is done.
Turn radius set-up
To change wheel max. turn radius, use mode switch. Left position of switch
indicates 900-degree mode, right position 270-degree.
Customizing turn radius
To change eective* turn radius according to personal preference, do as follows:
Change mode switch to 900 degrees position.
Press PROG button, red LED will start to blink.
Turn wheel to desired angle (min 60°) and hold.
Press OPTIONS button to conrm change.
*Wheel real turn range is unaected by this change, it only changes signal.
Clear single button assignment
Press PROG button, red LED will start blinking quickly.
Press desired FUNCTION button. Red LED will blink noticeably slower.
Press same FUNCTION button again. Red LED will solid lit and button
function is restored.
Clear all buttons assignment
Press PROG button, red LED will start blinking quickly.
Press and hold for 4 seconds OPTIONS button.
Safety information general
Use as directed.
Non-authorized repairs or taking the device to pieces make the warranty void
and may cause the product damage.
Avoid to hit or friction with a hard object, otherwise it will lead to grind
surface or other hardware damage.
Do not use the product in low and high temperatures, in strong magnetic
elds and in the damp or dusty atmosphere.
Do not drop, knock, or shake the device. Rough handling can break it.
Slots and openings in the case are provided for ventilation and should not be
obscured. Blocking the vents can cause overheating of the device.
The safe product, conforming to the EU requirements.
The product is made in accordance with RoHS European standard.
The WEEE symbol (the crossed-out wheeled bin) using indicates that this product in not
home waste. Appropriate waste management aids in avoiding consequences which are
harmful for people and environment and result from dangerous materials used in the
device, as well as improper storage and processing. Segregated household waste
collection aids recycle materials and components of which the device was made. In order
to get detailed information about recycling this product please contact your retailer or
a local authority.
EN
Programming pedals and PADDLES
as the Y axis
Press PROG button, red LED will start blinking quickly.
Press on D-PAD. Red LED will solid lit.
Button programming
Buttons ABXY, L1, L2, R1 and R2 (BASE buttons) - can be assigned to L-paddle,
R-paddle, throttle pedal, brake pedal, L3 and R3 (FUNCTION buttons).
Press PROG button, red LED will start blinking quickly.
Press desired FUNCTION button. Red LED will blink noticeably slower.
Press desired BASE button. Its default function will be assigned to previously
pressed FUNCTION button. Red LED will solid lit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
