Genesis STORM - Connecting Components; Sensor and Cable Connections; Tubing and Pump Power Connections

o IfusingyourSTORM™withtheROCv™module,placethe“ROCv™Min”sensorinsideashroud
andaffixittothesideofthebottomshroud,slightlyabovethe“TopOffBin”sensor.Thecord
onthesensorshouldcomeoutofthetopoftheshroud.

4. Connect
theComponents

NOTE:ALLWIRESSHOULDHAVEADRIPLOOPTOPREVENTWATERFROMENTERINGTHECONTROLMODULE

 PlugintotheControlModulethelevelsensorharnessthatcontainsthe“Aquarium/Sump”and“TopOffBin”
Sensors.Thisharnessplugsintothe6‐pinreceptacleonthelower
left‐handside(asyouarelookingatthe
backoftheControlModule).
 IfusingaROCvmodulewithyourSTORM™system,plugthelevelsensorharnessthatcontainsthe“ROCv
Max”and“ROCvMin”SensorsintotheControlModule.Thisharnessplugsintothe6‐pinreceptacle
onthe
lowerright‐handside(asyouarelookingatthebackoftheControlModule).
 Ifused,plugtheaquariumorsump’sFailsafeLevelSensorcableintothe2‐pinreceptacleonthelowerright‐
handside(asyouarelookingatthebackoftheControlModule).

 Ifused,plugthetopoffwaterbin’sFailsafeLevelSensorintothe2‐pinreceptacleonthelowerleft‐handside
(asyouarelookingatthebackoftheControlModule).
 IfcouplingyourSTORM™systemwithaRENEWautomaticwaterchangesystem(seeourwebsite
forwhyyou
wanttodothis!),plugthecommunicationharnesssuppliedwiththeRENEWsystemintothecenter6‐pin
receptacleonthebackoftheSTORM™ControlModule,andplugtheotherendintothecenter6‐pin
receptacleonthebackoftheRENEWControlModule.

5.
Attachasegmentofappropriatelysizednon‐toxictubingtoasubmersiblepumpandplacethepumpinthetopoffwater
bin.

6. Routethetubing  totheaquariumorsump.Thetubingshouldbesecuredsuchthattheendofthetubingisjust above
thehighestwater
levelintheintheaquariumorsump,sothatthewaterwillrundownthesideofthetankasthewater
leveldrops.Doingsowillimprovewaterflow,reducenoise,andpreventwaterfromsiphoningbackintothetopoffbin.
Cutthetubingtolengthifnecessary.


7. Plugthepump’spowercordintotheACreceptacleonthebottomrightoftheControlModule(whenviewingthefrontof 
theControlModule).EnsurethatadriploopisformedtopreventwaterfromenteringtheControlModule!

8. PlugtheControlModule’spowercordinto
aGFCI‐protected110VACoutlet.Ensurethatadriploopisformedtoprevent
waterfromenteringtheControlModule!YouarenowreadytouseyourSTORM™System!