ENGLISH
1
G
ENIUS
G
RAPHIC
T
ABLET
Q U I C K I N S T A L L AT I O N G U I D E
CAUTION: PLEASE
INSERT
THE
DRIVER
CD
INTO
YOUR
COMPUTER
FIRST
AND
THEN
FOLLOW
THE
INSTRUCTIONS
TO
COMPLETE
YOUR
SETUP
PROCESS.
INTRODUCTION
DRIVER INSTALLATION
Windows:
1. Insert the driver disc into your computer’s CD-ROM drive. When prompted, select “Driver Setup”, and press OK to
install driver.
Note: In most systems, the Setup Wizard will start automatically. If Automatic Setup does not begin, start the Setup
program manually by selecting “Start/Run”, type "E:\setup", where “E:” represents the location of the CD-ROM
drive, then press “Enter”.
Note: In certain cases, Windows might ask for your permission because it cannot recognize the driver you are
downloading. If this occurs, select “Continue Anyway” and continue to install.
2. Please insert the driver CD into your computer first and then follow the instructions to complete your setup process.
Macintosh:
1. Insert the driver disc into your computer’s CD-ROM drive.
2. Check to see if the “Genius Tablet” is shown on the screen. Double click the icon then follow the instruction.
3. Enter your administrator name and password to process the next step till it’s finished.
Note: For more information, refer to the MAC user manual on the driver disc.
CAUTION: ONCE
THE
INSTALLATION
HAS
BEEN
COMPLETED,
REBOOT
YOUR
MACINTOSH
BEFORE
PLUGGING
THE
DEVICE
INTO
YOUR
COMPUTER.
HARDWARE INSTALLATION
CAUTION:
MAKE
SURE
THAT
YOU
HAVE
INSTALLED
THE
DRIVER
SOFTWARE
(SEE
ABOVE)
INTO
YOUR
COMPUTER
BEFORE
INSTALLING
THE
HARDWARE.
1. Plug the Graphic Tablet USB cable into your computer’s
USB port (located on the computer, display, or keyboard).
The Graphic Tablet’s LED light will indicate the operational
status, and your computer screen will display a “found new
hardware” message.
1. Working area
2. Button 2
3. Button 1
4. Pen tip
To Next Page
Need help?
General
