1716
geniuschargers.com
CHARGING STEPS
USING THE G4
Checks the battery voltage to make sure battery connections are good and the
battery is in a stable condition before beginning the charging process.
Initializes the Recovery process, if needed, for deeply discharged or sulfated
(desulfation) batteries by pulsing small amounts of current.
Begins Bulk charging process with a gentle (soft) charge.
The Bulk charging process continues and returns 80% of the battery capacity.
Indicated by the 25%, 50% and 75% CHARGE LEDs.
Brings the charge level to 90%. The battery charger will delivery small amounts
of current to provide a safe, efcient charge and limit battery gassing.
Battery is fully charged and ready to use, indicated by the 100% CHARGE LED
being a solid Green. In this step, the battery charger will only delivery enough
current that the battery needs. If the battery tells the charger that more current
is needed, the battery charger will switch to Maintenance.
Continuously monitors the battery voltage to determine if a maintenance
charge should be initiated. If the terminal voltage falls below 6.4V (6V) and
12.8V (12V), the charger will start the Maintenance cycle until voltage reaches
7.2V (6V) and 14.4V (12V) and then discontinues the charge cycle. The cycle
between Trickle and Maintenance is repeated indenitely to keep the battery at
full charge, without overcharging. The battery charger can be left connected
indenitely.
USING THE G4
WICKED SMART FEATURE
AUTO-MEMORY. If at any time the battery charger is disconnected from
its power source, either from a power loss or accidentally disconnecting
the AC power plug from the electrical outlet, the battery charger will
remember the previously selected charge mode when power is restored.
The battery charger will automatically resume the charging process to
ensure your battery is fully charged.
WICKED SMART FEATURE
CHARGE LED’s. The CHARGE LEDs indicate the health of the battery
from 25% to 100%. 25% means weak and 100% means fully charged.
A “blinking” CHARGE LED indicates the current status of the charge
process. When the CHARGE LED turns “solid,” the charge process is
complete.
To Next Page
Loading...
Need help?
General
