Genius NS-6005 User Manual

Genius English
Wireless Mouse NS-6005 NS-6010 NS-6015
Model:
GM-120030/S for NS-6005
GM-130001/S for NS-6015
GM-130002/S for NS-6010
Hardware Installation
1. You can connect the receiver to a USB port of a PC.
2. Install one AA or AAA battery in the mouse as instructed.
3. Make sure that you have switched on the power switch underneath the mouse.
Note:
 When you put the receiver into the storage slot, the power switch will turn off.
You cannot use the mouse when the receiver is inside the mouse.
 Battery life may vary based on user and computing
conditions.
Factory Settings
1. Left Button: Provides traditional mouse functions like
click, double click and drag.
2. Magic-Roller: Press the “Magic-Roller” to surf the
Internet and Windows documents.
3. Right Button: Provides traditional mouse click
functions.
Warning: (Troubleshooting)
1. Do not use the wireless optical/laser mouse on a desk
which is made of glass or mirror.
2. The connection of the wireless device is factory preset, so when you plug the
USB receiver into any USB port, the connection between the micro receiver and
the mouse will be established automatically.
3. In case your PC did not install the hardware successfully, remove the micro
receiver from the USB port and go Human Interface Devices under Device

Genius NS-6005 Specifications

General

Type	Optical
DPI	1000
Buttons	3
Connection	Wired
Interface	USB
Technology	Optical
Resolution	1000 DPI
Sensor	Optical
Cable Length	1.5 m

Summary

Hardware Installation and Usage Notes

Hardware Installation Steps

Connect the receiver to a USB port, install batteries, and switch on the mouse.

Installation Notes

Notes regarding receiver storage, battery life, and mouse usage with receiver in slot.

Mouse Features and Settings

Factory Settings Overview

Details on Left Button, Magic-Roller, and Right Button functions for traditional and internet use.

Troubleshooting and Warnings

Surface Compatibility and Connection

Avoid glass/mirror surfaces; automatic connection established upon USB receiver insertion.

Connection Troubleshooting Steps

Procedure to remove and re-insert the micro receiver if PC fails to install hardware.

FCC Compliance Information

FCC Warning Statement

Information regarding modifications, Class B digital device limits, and potential radio interference.

Interference Correction Measures

User guidance on correcting interference by reorienting antenna or adjusting separation.

Safety and Disposal Instructions

Battery Replacement Caution

Warning about explosion risk if battery is replaced with an incorrect type.

Battery Installation Procedure

Steps for installing a fresh AA battery, ensuring correct polarity and cover locking.

Product Disposal Guidance

Instructions for responsible disposal within the EU to prevent environmental harm.