If the machine tilts 15°+5° above the horizontal plane for more
than 1 second, the machine will stop running immediately, the
laser module will stop laser output, and the status light will display
an alarm. While in a protected state, the machine must be
restarted to resume normal operation.
The flame sensor will trigger audible and visual alarms. When an
open flame is detected, the machine stops working and the laser
module stops output immediately. The status light displays an alarm.
When it enters protection mode, the machine must be restarted to
work normally.
04 Product Functions and Introduction
10
1. Tilt Protection
Emergency stop switch when the emergency stop button is
pressed, the power of the machine will be cut off in time and the
machine will completely stop working. After turning the emergency
stop switch clockwise, release the emergency stop switch and
the machine enters reset mode.
3. Reset Mode
2. Alarm Protection
After inserting the key and turning it right, the machine's power is
restored and enters reset mode. When using the machine, turn
the key left and the power of the machine will be cut off in time,
the machine will stop working completely.
4. Key Switch Function
Alarm
Emergency stop
Flames
Key switch
function
Alarm
To Next Page
Loading...