Barometric Pressure Indication
Red light flashing: No airflow. Smoke and dust may contaminate the
lens during the engraving or cutting process. Please check the working
status of the air pump and ensure that the silicone tube is connected.
Green light is always on: Air currents. The airflow can be adjusted
according to personal needs when cutting.
Flame Instructions
Green light is always on: Detect whether the processing material is
burning.
Red light: lf a flame is detected, it is recommended to stop the current
work immediately to ensure safety.
Light Bar Display
Laser light bar: Currently used laser power value
04 Product Functions and Introduction
11
LED Status:
WiFi connection status: flashes on for 0.2S and off
for 0.2S
Warning status: flashes, on for 0.5S and off for 0.2S
Open the door, flame alarm, tilt protection: flashes, on
for 0.5S, off for 0.5S
Engraving status: breathing flashes
Standby mode: light always on
Light strip
Flame instructions
Barometric pressure indication
Light bar display
To Next Page
Loading...
