Safety Instructions
Thank you for purchasing Genmitsu laser engraving machine. For a better use and maintain of this equipment, please read the
manual carefully and follow the steps in the manual.
CAUTION
All risks caused by improper use or failure to follow the steps in the manual are borne by the individual. The final interpretation right
of the manual belongs to the company, and has the right to modify all materials, data, technical details, etc. in this manual.
Before operating the equipment, please read the user manual carefully and strictly abide by the operating procedures.
Laser processing may have risks, users should carefully consider whether the object to be processed is suitable for laser
operation.
Processing objects and discharges should comply with local laws and regulations.
The environment where the equipment is located should be dry, free from pollution, vibration, strong electricity, strong magnetism and
other interference and influence. The working environment temperature is 5-30℃, and the working environment humidity is 35-65%RH.
The engraving machine and other associated equipment must be safely grounded before it can be turned on for operation.
Ignite the surrounding combustibles;
During laser processing, other radiation and toxic and harmful gases may be produced due to different processing objects;
Direct irradiation of laser radiation will cause human injury. The place of use must be equipped with fire-fighting equipment. It
is forbidden to pile up flammable and explosive materials on and around the workbench, and at the same time, it must be well
ventilated.
02
WARNING
Equipment working voltage: AC100-240V.
It is strictly forbidden to place any irrelevant total reflection or diffuse reflection objects in the device to prevent the laser from
reflecting onto the human body or flammable objects.
The device should be far away from electrical equipment sensitive to electromagnetic interference, which may cause electromagnetic
interference.
There is high voltage or other potential dangers inside the laser equipment, non-professionals are strictly forbidden to disassemble.
When the equipment is turned on, it needs to be on duty all the time. All power must be cut off before leaving to prevent abnormal
situations. If any abnormal situation occurs, please cut off the power immediately!
①
②
③
To Next Page
Loading...