APP Download & Introduction
1. APP Download and Test Engrave.
2. Setup your Laser Engraver.
a. Connect the Z4 Engraver to the power supply and power on.
b. Enable bluetooth on your mobile phone or tablet.
c. Open "Engraver" and click "Not Connected" in the upper right corner. The
app will search for available devices.
d. Then click "Genmitsu_Z4xxxxx".
e. The machine will be connected to your phone within a few seconds. The
upper right corner will show "Connected". You can now start engraving your
first job with the app.
① Start your first test engraving.
② Select Photo either one of your own, or select samples from the “Image
Library”.
③ You can Crop, Add Text, or additional Images after selecting your desired
photo/drawing.
④ Select “Next Step” from the top right corner when complete.
⑤ Adjust your Image, Black and White, Grayscale, Outline only, Sketch Filter,
or Rotate.
⑥ Select “Next Step”
⑦ You can preview your project and prepare to position the Laser Engraver
on your material.
⑧ Use Trace or Outline to help you place your image on the desired engraving
surface.
⑨ When ready select Start Engrave.
⑩ Wait for the engraving process to complete before moving the engraver.
⑪ Congratulations, in just a few moments you created your first engraving!
Note:
Corresponding permission should be granted
after successful installation.
Method 2: Download from SainSmart
Resources Center:
https://docs.sainsmart.com/z4. Other
resources like the user manual and
video instructions can also be
downloaded here.
Method 1: Scan the following QR code to
download
10
To Next Page
Loading...