EasyManua.ls Logo

Gentech GP3500i - Generator Operation, Alarms, and Reset

Gentech GP3500i
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Caution
Do not overload the generator. Low Oil Alarm (Red)
When the engine oil falls below the required level the Low Oil Alarm will come
on and the engine will stop automatically. The engine will not restart until oil is
added to the unit to bring it up to the appropriate level.
6.3 TO RESET THE GENERATOR
6.3.1 Turn off any connected electric devices and stop the engine.
6.3.2 Reduce the total wattage of the connected electric devices
within the rated output.
6.3.3 Use in proper ventilated areas. Maintain at least 1m of
clearance on all sides for adequate cooling.
6.3.4 After checking, restart the engine.
Note:
The Overload Alarm may come on for a few seconds when
first using electrical devices that require a large starting
current, such as compressors, pumps or refrigerators.
When starting the unit, if the Low Oil Alarm light flickers and
the engine will not start, you will need to add engine oil
before attempting to restart the engine.
The generator should only be operated on a level
surface.DO NOT operate the generator on loose ground or
obvious inclines. The low oil shutdown feature may be
prematurely activated causing the engine not to start.