EasyManua.ls Logo

Geofire Salamander - Controller Command Codes; Locking and Unlocking the Keypad

Geofire Salamander
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
S A L A M A N D E R USE R G U I D E
1-11-9330 issue B
8
Command Codes
Press the * RELEASE and Un Enrol buttons at the same time to enter command codes.
Once the buttons are released, the number display flashes “00” to indicate command mode.
Use the up and down arrows to select the code number then press * RELEASE.
The codes are as follows:
00 Set key-lock code, see over page
01 lock keypad now
02 (Consult Salamander system installer / maintainer)
03 (Consult Salamander system installer / maintainer)
04 (Consult Salamander system installer / maintainer)
05 (Consult Salamander system installer / maintainer)
06 door holder statistics, see the Display Unit Statisticssection
07 (Consult Salamander system installer / maintainer)
08 fire/fault reset delay : 60 (30 minutes default) / 01 (30 seconds)
09 display channel number
10 toggle poll frequency: 1h (1 hour frequency) / 2h (2 hours - default)
11 un-enrol a booster
12 (Consult Salamander system installer / maintainer)
13 booster statistics, see the Display Unit Statisticssection
14 display back-up battery condition
15 toggle status query of boosters “Pr” = Poll Repeaters (default) / “nP” = No Poll
Locking the Keypad
1. Select command code 00 and press * RELEASE
2. A static “00” is now displayed
3. Decide on a security code number for unlocking the keypad (4 or more digits
recommended)
4. Use the up and down arrows to select the first digit
5. Press Un Enrol and then select the second digit. Repeat as necessary
6. After entering the last digit press * RELEASE instead of Un-enrol. The keypad will
now lock
Any press of the buttons other than Activate will show Cd on the display. Enter the security
code as in 4 to 6 above using the up and down arrows, Un Enrol and * RELEASE. OP will
be displayed.
The keypad will lock again after 5 minutes of no use, or if command option 1 is selected.
If the security code is lost or set by mistake, use the engineers unlock code 3142.
To switch off key locking proceed as if to set a locking code and enter the new security code
00, i.e. complete steps 1 and 2 then press * RELEASE again.