Geofire Salamander - Displaying Unit Statistics; Door Holders and Closers Statistics; Booster Unit Statistics

To Next Page

To Previous Page

S A L A M A N D E R USE R G U I D E

1-11-9330 issue B

Display Unit Statistics

Door Holders and Closers

Enter command code 06. Use the up and down arrows to select the door holder number and

press * RELEASE.

 First the received signal strength at the door holder is displayed (63 maximum)

 Press *. Now the signal strength received at the controller is displayed (63 maximum)

 Press *. The battery strength is displayed (39 = max, 32 = min)

 Press *. The node with which it is synchronised (0 = controller, 1-8 = booster number)

 Press *. The top 2 digits of the holder serial number

 Press *. The middle 2 digits of the serial number

 Press *. The last 2 digits of the serial number are displayed

 Then either select another door holder or press Un Enrol to return to OP

If the first display is “nc”, this means that there are no valid statistics for this unit (the unit did

not reply to the last query). “Un” here means that there is no unit enrolled in this slot. If “nc”

is displayed, the serial number will still be displayed when pressing * RELEASE for this unit

to allow for troubleshooting.

Boosters

Enter command code 13. “r1” is displayed. Use the up and down arrows to select the

booster number and press * RELEASE.

 First the received signal strength at the booster is displayed (63 maximum)