Zenith15/25 GNSS Series - 2 -
Installation Guide © 2017 GeoMax AG, Widnau, Switzerland
Tablet of Contents
1 INTRODUCTION
2 GENERAL PREPARATION
2.1 Copy Zenith15/25 Firmware on MicroSD card
2.2 Battery Charging
3 PREPARATION OF THE GNSS RECEIVER
3.1 Connecting to the PC
3.2 Receiver connection with GeoMax Assistant
3.3 Checking the receiver firmware version
3.4 Changing the UHF radio settings
3.5 Antenna Management
3.6 Installation of licences
3.7 Disconnecting from the PC
4 PREPARATION OF THE HANDHELD
4.1 SETTING UP WINDOWS MOBILE
4.2 Connecting to the PC
4.3 Installation of FieldGenius/ Layout Pro
4.4 Registration of FieldGenius/ Layout Pro
4.5 Connection to the GNSS receiver
5 EQUIPMENT SETUP
5.1 Rover setup
5.2 Base setup
To Next Page
Loading...
Need help?
General
