Need help?Do you have a question about the GeoMax Zenith10/20 SERIES and is the answer not in the manual?
General| Type | GNSS Receiver |
|---|---|
| Static Positioning Accuracy (Vertical) | 5 mm + 0.5 ppm |
| Data Logging Rate | Up to 20 Hz |
| Operating Temperature | -40°C to +65°C |
| Ingress Protection | IP67 |
| Battery Life | Up to 10 hours |
| Communication | Bluetooth |
Instructions for charging the ZBA202 batteries for the GNSS receiver using the ZCH202 charger.
Steps for charging the internal battery of the Getac PS236 handheld device.
Guide to downloading and installing the GeoMax Assistant software on your PC.
Procedure for connecting the GNSS receiver to the computer using a USB cable.
Establishing a connection between the GNSS receiver and the GeoMax Assistant application.
Verifying the current firmware version of the GNSS receiver and initiating an update if needed.
Initial configuration steps for the Windows Mobile operating system on the Getac PS236.
Connecting the Getac PS236 handheld device to your PC via USB for software installation.
Downloading and installing the FieldGenius software onto the handheld device.
Activating and registering the FieldGenius software using a license key and Device ID.
Establishing a connection between FieldGenius on the handheld and the GNSS receiver.
Prerequisites and necessary components for updating the GNSS board firmware.
Step-by-step guide to performing the GNSS board firmware update using specific tools.
Instructions for setting up the Zenith10/20 equipment as a RTK or network rover.
Guide for configuring the Zenith10/20 equipment as a base station for RTK corrections.
To Next Page
