Zenith10/20 GNSS Series - 4 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
2 BATTERY CHARGING
2.1 ZENITH10/20 GNSS RECEIVER
The GNSS receiver, batteries and charger are supplied in a yellow hard container.
Before using the receiver, the included ZBA202 batteries should be charged. Insert
two batteries into the ZCH202 charger and plug the adapter into an AC supply. Do not
disconnect from power until both the FULL indicators glow green, indicating that the
batteries are fully charged.
2.2 GETAC PS236 HANDHELD
The PS236 handheld is supplied in a cardboard box which includes the handheld device,
battery, charging adapter and EU power cable. A suitable AC power cable may need to be
sourced locally to suit country specific plugs. All AC voltages are supported by the
adapter.
Insert the supplied battery into the handheld’s battery compartment. Charge the internal
battery with the supplied adapter as shown below. While charging, the circled indicator
on the front of the PS236 glows amber. Do not disconnect from power until the indicator
glows green, indicating that the battery is fully charged.
To Next Page
Loading...
Need help?
General
