Zenith10/20 GNSS Series - 11 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
4 PREPARATION OF THE HANDHELD
4.1 SETTING UP WINDOWS MOBILE
Once the battery is fully charged or while connected to AC power, press the power
button of the handheld. Follow the steps of the wizard to setup Windows Mobile. The
Windows Mobile software on the supplied Getac PS236 is only available in English
language. Microsoft restricts the installation of alternative languages with this
operating system.
4.2 CONNECTING TO THE PC
If using Windows7 or Vista on your PC, the Windows Mobile Device Centre needs to be
installed. For earlier versions of Windows, install Microsoft ActiveSync. Both these
applications are supplied on the Getac Getting Started CD or can be downloaded from
Microsoft’s website. After the software installation, connect the handheld to your PC
with the USB cable supplied with the PS236 as shown below.
The device drivers will now automatically be installed. If the Windows Found New
Hardware Wizard starts, click the Close button. After the drivers are installed, the
Mobile Device Centre or ActiveSync will automatically start. The contents of the
PS236 internal memory can be seen with Windows Explorer and are defined as a drive
named Portable Device.
To Next Page
Loading...
Need help?
General
