Zenith10/20 GNSS Series - 2 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
Tablet of Contents
1 INTRODUCTION
2 BATTERY CHARGING
2.1 Zenith10/20 GNSS receiver
2.2 Getac PS236 handheld
3 PREPARATION OF THE GNSS RECEIVER
3.1 Installation of GeoMax Assistant
3.2 Connecting to the PC
3.3 Receiver connection with GeoMax Assistant
3.4 Checking the receiver firmware version
3.5 Changing the UHF radio settings
3.6 Installation of licences
3.7 Disconnecting from the PC
4 PREPARATION OF THE HANDHELD
4.1 Setting up Windows Mobile
4.2 Connecting to the PC
4.3 Installation of FieldGenius
4.4 Registration of FieldGenius
4.5 Connection to the GNSS receiver
5 GNSS BOARD UPDATE
5.1 Requirements
5.2 Update process
6 EQUIPMENT SETUP
6.1 Rover setup
6.2 Base setup
To Next Page
Loading...
