Zenith10/20 GNSS Series - 3 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
1 INTRODUCTION
This guide provides complete step-by-step instructions for preparing the Zenith10/20
GNSS for measuring work. The instructions cover all the required installation tasks for
the Zenith GNSS receiver, Getac PS236 handheld and FieldGenius software.
Only the tasks required for the initial setup of a new Zenith10/20 system are
described in this document. For further information regarding the operation of the
Zenith10/20 components, please refer to the respective User Manuals.
The User Manual for the GNSS receiver is available from the Zenith10/20 CD and also
from GeoMax Downloads at http://www.geomax-positioning.com/downloads_457.htm
The Getac PS236 User Manual is supplied on a CD packed together with the handheld.
The FieldGenius manual can be downloaded from the MicroSurvey website, at
http://www.microsurvey.com/support/ in the downloads section as shown below.
To Next Page
Loading...
Need help?
General
