Zenith10/20 GNSS Series - 23 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
6.2 BASE SETUP
The Zenith10/20 equipment can also be setup as a base station for the transmission
of RTK corrections as shown below.
Attach the supplied radio antenna to the receiver plug labelled UHF. To provide space
for the radio antenna, the receiver should be mounted onto the 792381 ZPC210 Base
Pole. The required RTK output message can be configured using GeoMax Assistant or
FieldGenius.
For long range RTK, a high powered radio can be used at the base station. Available
from GeoMax is the 789359 Satel EASyPro 35W radio. This radio is connected to the
receiver and an external power supply, with the 792382 ZDC221 cable. The cable
needs to be connected to the 5-pin Lemo port of the receiver. When other UHF radio
types are used, a suitable cable needs to be obtained from the radio supplier.
To Previous Page
Loading...
