Zenith10/20 GNSS Series - 19 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
5 GNSS BOARD UPDATE
5.1 REQUIREMENTS
Occassionally it may be necessary to upgrade the NovAtel GNSS board firmware. The
currently installed version can be viewed using GeoMax Assistant. Once the receiver is
connected with Assistant, the board firmware can be seen in the Information window,
at the GPS Firmware Ver field (example version below is 3.803). Visit GeoMax
Downloads to check for the currently available firmware version. If this is not the
same version as installed, then the receiver needs to be updated.
5.2 UPDATE PROCESS
To perform a GNSS board firmware update, the ZDC220 serial cable is needed. This
cable can be ordered from GeoMax with article number 789348. In addition to the
USB cable, connect the ZDC220 between the 5-pin Lemo port of the receiver and the
serial plug on your PC.
To Next Page
Loading...
