Zenith10/20 GNSS Series - 18 -
Installation Guide
© 2011 GeoMax AG, Widnau, Switzerland
The Link Configure panel is now displayed. In the Link Device field, the following
choices are available:
- None: When only raw data logging
- Other Device: When using an external radio
- GSM Module: For network rover
- UHF Radio: For the internal radio as base or rover
Choose the required device and then tap Setup to configure the device. When using
the GSM Module, the NTRIP parameters can be entered. Once an internet connection
is established, a suitable mountpoint can be selected. With the UHF Radio, the
required frequency channel can be selected.
On return to the Link Configure panel, set a suitable Data Format that matches the
mountpoint or RTK base message, for example RTCM3.
When everything has been configured as required, tap Connect. The map view is
shown next and you are ready to measure. For further information on using
FieldGenius for GNSS measurements, refer to the FieldGenius instruction manual in
the GPS REFERENCE chapter.
To Next Page
Loading...
Need help?
General
