12/22
NB:
1. If the Target zone is activated, if you go over the upper limit an alarm will sound, 2 beeps every 10
seconds. If you go over the lower limit the alarm will beep once every second.
2. You can use the upper or lower limit only by entering an unattainable value for either.
3. The target zone is activated when it is ON and the exercise stopwatch is started.
7 / Exercise report mode (DATA)
Data storage rules:
The report is reset when the training stopwatch is started for the rst time: if a user goes in to DATA mode at
that time, he or she will see NO DATA. The data is stored in the memory when the user stops the stopwatch:
if the user goes into DATA mode he or she will then see the training report for the workout just ended.
You can view the training report "during" the training session. To do this, press the START/STOP
quickly twice to stop the stopwatch for a fraction of a second. The interim report will then be
stored until the user presses START/STOP again. The interim report cannot be saved and will be
replaced by the nal report at the end of exercise 1.
To Next Page
Loading...
