EasyManua.ls Logo

GEORGE FISCHER MSA 250SE - User Manual

GEORGE FISCHER MSA 250SE
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Item #1167 (7/16)
© Georg Fischer LLC
Printed in USA
GF Piping Systems
MSA 250SE
Technical and Operation Manual
Question and Answer IconNeed help?

Do you have a question about the GEORGE FISCHER MSA 250SE and is the answer not in the manual?

Summary

Introduction

Validity

Specifies the validity of the operating instructions for the MSA 250SE series units.

Product Description

Details the MSA 250SE as an electrofusion power control unit for joining polypropylene fittings.

Power Supply

Describes the unit's design for single-phase AC power (110VAC/60Hz) and warns against DC use.

Main Supply

Outlines requirements for power connections, including safety conductors and fuses.

Generator Operation

Discusses generator output requirements varying with generator settings and environmental factors.

Fusion Cables

States that only factory-supplied cables should be used for fusion.

Extension Cord

Specifies the required length and gauge for an extension cord.

Starting Up

Provides steps for safe startup, including confirming power connections and air supply.

Operation Controls

Identifies the location of display and control functions on the front panel.

Switching On

Details the process of turning the unit on and its indicators.

Operation with Barcode Reader

Time-based Fusion

Explains how the fusion time may change due to temperature compensation after connecting the fitting.

Multiple Joint Fusion Capability

Lists the capabilities for joining different sizes of Fuseal and PPro-Seal fittings.

Manual Operation

Manual Input of Fusion Time and Voltage

Describes the step-by-step process for manually entering fusion time and voltage using the UP key.

End of Fusion

Interrupting the Fusion Process

Product Specification

Error Messages

Maintenance

Cleaning

Instructions for cleaning the unit and barcode reader, with warnings against water immersion.

Operational Check

Notes the necessity of regular operational checks and calibration by an authorized service agent.

Industrial Safety Regulations

Covers safety regulations for operating the unit, including training and environmental risks.

Operating the Unit

Details conditions for safe operation, including proper handling, maintenance, and supervision.

Check before Operation

Advises checking the unit for damage and proper mounting before each operation.

Protection of the Unit

Guidance on protecting the unit from sharp edges and mechanical strain, and handling damaged cables.

Defective Unit

Procedures for repairing defective units or parts by an authorized service agent.

Opening the Unit

States that only authorized service agents can open the unit due to electrical hazards.

GEORGE FISCHER MSA 250SE Specifications

General IconGeneral
BrandGEORGE FISCHER
ModelMSA 250SE
CategoryWelding System
LanguageEnglish

Related product manuals