Warning: Always test gas line for leaks at connector
with soap water around all connections.
ATTACHING YOUR GAS BOTTLE
After purchasing your gas cylinder you will then be ready to set it up
with your gas grill.
When changing the gas cylinder it must not be near any source of
ignition. Position the gas cylinder at the left side of your gas grill,
keeping in mind that the bottle must be kept away from heat and in a
safe position.
• When ready to use your gas grill place the regulator onto the gas
bottle valve and push down firmly until you hear it click in to place.
• Attach the hose to the regulator gas outlet, you will need to push
firmly as it is a tight fit.
• Once the hose is connected to regulator it must be secured in
place using one of the two jubilee clips supplied.
• Attach the other end of the gas hose to the gas inlet on the
appliance, again you will need to push firmly as it is a tight fit.
• Once the hose is connected use the second jubilee clip to secure
in place.
• Ensure that the hose is not subjected to twisting which will affect
the gas flow when installing your gas grill. Also the hose must not
have undue tension and must not touch any part of the gas grill
which may be hot.
• Once the gas cylinder is connected to the appliance you can then
start the flow of gas by turning the small lever on the regulator from
its closed position (vertical) to its open position (horizontal).
9
To Next Page
Loading...
