SP 250E
MAINTENANCE:
3. Maintenance
1) clean the dust and dirt on the surface
2) wash the tank with water and clean it
3) check the connection and ensure no leaks
4) check the screws and ensure no loose and lost
5) wash the diaphragm pump with water
2. Long-term storage
1) the machine should be keep 50cm high above the ground
2) charge every 2-3 months
3) keep the machine at a cool, dry and ventilated place
Operating instruction:
1. Be sure to charge the battery sufficiently before use, insert the charger
pin to 220v power socket until the light comes green . There is protection design
at the charger jack and put on the plastic com if not charging.
2. Trial spraying with clean water is necessary for initial use. so as to make
sure neither leakage nor poor atomization occurs.
3. Never use such special liquid as strong acid, strong base and flammable
goods. Power are not allowed.
4. Don’t operate this sprayer at a place with a temperature exceeding 45°
C or lower than 10° C.
5. Fill the water and chemical liquid through filter.
6. If spilling out when filling the chemical water, please clean it
immediately.
7. Close the cover tightly after filling, in ease of spilling during spraying.
8. Turn on the power switch and clench the switch handle to starting
spraying. Loosing the switch handle, spraying will stop and pump shut down.
Altering finishing the spraying in the tank, the pump will continuing work, turn
down the power.
To Next Page
Loading...