9. SPRAYING ATTENTIONS:
1) After turn on the power switch, please swing the spray rod. Always
spraying at one place will cause damage.
2 ) Never spray against the wind and keep a up angle of about 15° .
3) During spraying, waving the rod to increase the spraying volume,
talking pace should match the waving pace.
4) It’ s better to do the spraying work in the morning or afternoon.
10. After turn down the power, clench the switch handle several times to
spray out the remaining chemical water.
11. Must check the chemical liquid operation requirement to avoid damage
to the people and environment.
12. Must discharge all the liquid inside to avoid damage to the machine
when keeping it at cold place.
13. The battery must be sufficiently charged before storage, especially
after use.
Structure and features:
1. Structure
The sprayer consists of a barrel, a base, a battery, a mini-pump, a charger, a
spraying system (rubber tubes, switch, spray rod, nozzle), belts, etc.
2. Features
1) The barrel back is designed according to the principle of ergonomics,
easy to backpack.
2) Using a mini diaphragm pump which is small si«, light weight, high
pressure, durable, and featuring a pressure protection switch to allow automatic
pressure-limit protection.
3) With filter protection to prevent foreign matters or particles from
blocking the nozzle.
4) With a special charger, the indicator lamps of charger Red-Charging;
Green - Charged/ Standby.
SAFETY ATTENTION
Danger may happen when using this machine. You are required to familiar
yourself with and follow the safety protection methods to ensure your personal
and other's safety.
1) Severe damage may be caused by improper use. never spray at human.
11) Don’t leave or keep the machine be in no charge. turn down the power
if not use. Don't put toxic chemical liquid in the barrel and keep the machine at
the place without direct sunshine.
To Next Page
Loading...