To Next PageTo Next Page
Need help?Do you have a question about the GeoVision GV-FER5702 and is the answer not in the manual?
General| Brand | GeoVision |
|---|---|
| Model | GV-FER5702 |
| Category | Security Camera |
| Language | English |
Step-by-step instructions for mounting GV-EBD cameras, including ceiling installation.
Step-by-step instructions for mounting GV-ABL/TBL cameras on walls or ceilings.
Step-by-step instructions for mounting GV-ADR/TDR cameras, including ceiling installation.
Step-by-step instructions for mounting GV-AVD/TVD cameras, including ceiling installation.
Step-by-step instructions for mounting GV-TFD cameras, including ceiling installation.
Step-by-step instructions for mounting the GV-FER5702 Fisheye camera.
Step-by-step instructions for mounting the GV-PTZ5810-IR PTZ camera.
Lists the hardware and software requirements for using the camera system.
Basic steps to connect the IP camera to your network for access.
Guide to finding the camera's IP address and logging into its web interface.
Instructions for assigning a static IP address to the camera.
How to view the live video feed from the connected IP camera.
Interface for controlling Pan, Tilt, and Zoom functions of PTZ cameras.
How to access and review recorded video footage from the camera's storage.
Configuring camera network settings, including IP, DNS, ports, and DDNS.
Setting IP address, subnet mask, gateway, and IPv6 configuration.
Configuring video stream parameters like compression, resolution, and frame rate.
Adjusting video compression, resolution, frame rate, and bitrate.
Basic PTZ settings including home position, limits, and control timeouts.
Adjusting image settings like brightness, exposure, OSD, and privacy mask.
Fine-tuning image parameters such as brightness, saturation, contrast, and exposure.
Configuring intelligent video analytics for event detection.
Enabling and configuring various smart detection events like Cross Line and Intrusion.
Setting up cross-line detection rules and trigger actions for alarms.
