P.8 P.9
Getting Started Operating Instructions
Air Duct Angle Setting
Before adjusting the air duct angle, please make sure the product is turned off. Hold
product body with one hand and set the air duct 15° forward or backward.
Switch ON and OFF
1. Connect to power source, and product will enter into Standby Mode.
2. Press On/Off
, the buzzer will beep once, and product will start to operate.
3. To turn off the product, long-press 2 seconds, the buzzer will beep once, and
product will stop operating.
Main Body
Battery Replacement
1. To open the battery cover at the bottom of the Remote Control, press the
buckle on the battery cover inward and pull it out.
2. Identify the polarity of the battery, and insert the battery into the battery slot.
3. Reinsert the battery cover into the bottom of the Remote Control.
Attention:
1. If Remote Control will not be used for a prolonged period of time,
please remove the battery.
2. This battery is not rechargeable. DO NOT recharge the battery.
3. The Remote Control and battery are not toys. Please keep them out of
children’s reach.
4. If accidentally swallow battery, please seek medical attention immediately.
Attention:
1. When operating in Warm Air Mode, the air duct will become hot. Shortly
after the product is turned off, it may still be hot to the touch. Please be
cautious.
2. This product has a built-in Overheat Protection Sensor, which is an
automatic fail-proof safety protection that cuts off power automatically
when the product is accidentally tipped over or overheats. If this sensor
is triggered and the product is stopped, unplug the product and let it cool
down.
To Next Page
Loading...