German pool GPI-M6 - 2 Description of Appliance; Technical Specifications; Dimensions; Scope of Delivery

P.6
P.7
2. Description of Appliance
2.2 Dimensions
Dimensions: mm
2.3 Scope of delivery
186
115
15
4.5
135155
141
87
25
30
150
Instantaneous water heater
Fixing screws and plugs
Operating and installation
instructions
Wall bracket
2. Description of Appliance
This instantaneous electric water heater is intended to provide the economical heating of water sufcient for a
single outlet, i.e. handwash basin, and is installed together with a sanitary water tting.
When the hot water tap is opened, the instantaneous electric water heater switches itself on automatically
and heats the water as it passes through the appliance. It is only then that the appliance uses electricity.
The temperature increase depends on the ow rate.
2.1 Technical specications
Model GPI-M6
Energy efciency class A
#
Capacity 0.2 l
Rated pressure 1 MPa / 10 bar
Minimum resistance of the water at 15 °C 1100 Ω cm
Maximum water inlet temperature 20 °C
Supply voltage 1~ / N / PE 220 V AC
Nominal power rating 6.0 kW
Nominal current 27.3 A
Hot water ow rate at ∆t = 25 K
1)
3.4 l/min
Switching on at 2.2 l/min
Minimum required cable size 4.0 mm
2)
Approx. weight (lled with water) 1.5 kg
Product dimensions (Height × Width × Depth) 13.5 × 18.6 × 8.7 cm
Connecting type pressure resistant / pressureless
Heating system IES® Bare wire heating system
VDE approv. / Protec. class VDE / IP25
#) The declaration complies with the preliminary requirements of the EU regulation No 812/2013.
1) The specic resistance can be asked for at your water distribution company.
2) Temperature increase from e. g. 15 °C to 40 °C.
• Specications are subject to change without prior notice.
• If there is any inconsistency or ambiguity between the Chinese version and the English version, the
English version shall prevail.
• Refer to www.germanpool.com for the most up-to-date version of the User Manual.
• Under normal working conditions, incoming pressure should not exceed 0.6 MPa. Otherwise, a
separate pressure control device is necessary.
• When incoming water pressure exceeds 0.6 MPa, German Pool will not provide any repair service until
a pressure control device is installed.