P.20 P.21
WARNING!
Before maintenance and repair, turn off the product, unplug the power source, and wait till
the product has completely cool down.
1. After each cooking session, empty water tank to avoid residual water causing coagulation or
breeding germs.
2. After each cooking session, please wipe oven door seal with warm wet cloth, then wipe dry
with soft cloth.
3. Over time, holes or cracks may form on the oven door sealing strip; when this happens, the
sealing strip will have to be replaced.
4. After each cooking session, please use wet cloth to wipe off stains in the oven cavity, then
wipe dry with soft cloth.
5. Most cooking stains can be wiped off with cloth soaked in mild detergent or warm water.
6. After each cooking session, please use dry cloth or other tools to clean and dry off residual
water collected in the water trough (located at bottom front of the oven cavity).
Taking Out the Oven Door
1. Open the door completely, lift upwards to unhinge the door.
2. Grasp the door firmly, then slowly close the oven door.
3. When the door is almost shut, the hinge part will come loose from the door frame.
4. Lift to take out the door, and place it carefully on a level surface.
Re-installing the Oven Door
1. Grasp the door firmly, slide the hinge securely back into the door frame.
2. Open the door completely, press the hinge downwards until it latches onto the frame.
3. Close the oven door and make sure it has latched on securely.
CLEANING OVEN DOOR GLASS AND DISPLAY PANEL
1. Clean oven door and Control Panel regularly. Remove stubborn stains with cloth moistened
with neutral detergent.
2. DO NOT use hard brush, scouring pad or wire scrubber to clean the product as it may
scratch its surfaces. Dry off with clean soft cloth.
CLEANING THE OVEN CAVITY
1. Use warm water or neutral detergent, do not use abrasive cleansers.
2. Use soft nylon brush to clean off stubborn stains, do not use steel scourer ball to avoid
scratching the product’s surfaces.
3. When using cleaners to clean the oven cavity, make sure it is completely rinsed off, then
use soft cloth to dry all surfaces completely, and keep the oven cavity dry at all times.
Cleaning & Maintenance
WARNING!
• Before maintenance work, turn off the product and unplug product from power source.
• This product must be installed and repaired by the manufacturer’s authorized after-sales
personnel only; if consumers entrust personnel not designated by the manufacturer, or if
consumers perform reparation work on their own, there may be a risk of personal injury or
property loss.
Troubleshooting
ERROR CODE POSSIBLE CAUSE SOLUTION
E1
Temperature Sensor may be open
circuit
Contact Customer Service &
Repair Centre
E2 Water pipe may be damaged
E3 Evaporator may be damaged
E4 Heating elements may be damaged
E5 Circuitry may be damaged
OPEN
Oven door is not properly closed
during operation
Close oven door properly
To Next Page
Loading...
