Gesipa FireBird User Manual (English)

Other manuals for Gesipa FireBird

Operating Instructions17 pages

Operating Manual6 pages

Questions and Answers:

J
Jimmy BrownJul 27, 2025
What to do if the red lamp indicates a fault while pressing the trigger button on Gesipa FireBird?
- N
  Nicole GregoryJul 27, 2025
  If the red lamp indicates a fault while pressing the trigger button, it might be because the blind rivet nut setting tool is not in the front end position. Try releasing the trigger button.
A
Amber RamirezJul 31, 2025
Why does the red lamp indicate fault during pulling operation on my Gesipa FireBird Power Tool?
- D
  David BradleyAug 1, 2025
  The red lamp may indicate a fault during a pulling operation due to several reasons. It could be caused by an overload; ensure you are using the tool within the specified working range. Another cause might be the electronics overheating, in which case, allow the tool to cool down in the air. Finally, check the battery level, as a discharged battery can also trigger this fault; charge or replace it as needed.
G
garciaheidiAug 5, 2025
What to do if the blind rivet nut does not screw on Gesipa Power Tool?
- K
  Kathy CareyAug 6, 2025
  If the blind rivet nut does not screw on, there are several possible causes. The nut thread or the threaded mandrel might be defective, in this case use a new nut or change the threaded mandrel. Ensure the nut rests against the nosepiece, adapting the threaded mandrel length if necessary. If the battery switched off because it has been idle for longer than 21 days, place battery in the charger for 2 minutes. If the battery is discharged, charge it or replace if necessary. Ensure that while it is screwed on, hold the nut until the tool stops and keep switch K pressed until the tool stops.
A
April LeeAug 11, 2025
Why is the set blind rivet nut loose on my Gesipa Power Tool?
- J
  jessicareevesAug 11, 2025
  A loose set blind rivet nut can occur if the setting stroke is too short; increase the setting stroke. Also, ensure that you keep switch K pressed until the automatic changeover and unscrewing are finished.
N
Nicole BrownAug 16, 2025
What to do if the threaded mandrel is not unscrewed from my Gesipa Power Tool?
- A
  Adam CraneAug 16, 2025
  If the threaded mandrel is not unscrewed, it could be due to an incorrectly adjusted setting stroke, so decrease the setting stroke. Another reason may be that the battery is discharged, so charge or replace the battery.