Why is the set nut loose with my Gesipa FireFox 2?
If the set nut is loose when using your Gesipa Rivet Tools, it could be due to several reasons. First, the setting stroke "Y" might be too short; in this case, increase the setting stroke. Alternatively, the setting force could be too low, so try increasing the setting force. Finally, check the air pressure and increase it to 5-7 bar if it's too low.
What to do if the nut is not removed by turning on Gesipa FireFox 2 Rivet Tools?
If the nut is not being removed by turning with your Gesipa Rivet Tools, several factors could be at play. The nut thread may be deformed due to excessive setting stroke or force; try reducing these settings. The removal period might be too short, so hold the activation button down for a longer duration. If the nut isn't automatically removed, keep holding the activation button down until it is. If the setting stroke or force isn't reached, continue holding the button and, if needed, refill the hydraulic oil and increase the network pressure to a maximum of 7 bar. If the nut is stuck on the threaded mandrel, reduce the setting force and attempt removal by pressing the removal button or unscrewing it with a hexagon screwdriver.
How to fix not possible to wind down nut on Gesipa FireFox 2?
If you're finding it impossible to wind down the nut on your Gesipa Rivet Tools, here are a few things to check: * The nut thread might be defective, so try using a new nut. * The threaded mandrel could be defective; in this case, replace it. * The winding process may not be starting; increase the setting stroke to the minimum.
Lists and illustrates the main components of the FireFox 2 tool.
Details the intended and exclusive application of the blind rivet nut tool for setting rivets.
Provides critical safety precautions and warnings for operating the tool safely.
Specifies the range of blind rivet nuts and bolts the tool is designed to set.
Lists key specifications including weight, pressure, capacity, and noise levels.
Details the included threaded mandrels, nosepieces, and other essential accessories.
Step-by-step guide for replacing worn or different sized threaded mandrels on the tool.
Instructions on adjusting the threaded mandrel length for optimal rivet setting.
Details the procedure for setting the tool's stroke length for consistent operation.
Explains how to adjust the setting force based on nut size and material thickness.
Instructions on positioning and winding the blind rivet nut onto the threaded mandrel.
Guide to initiating the setting process and ensuring proper rivet nut placement.
Procedure for manually removing the threaded mandrel if automatic removal fails.
General| Brand | Gesipa |
|---|---|
| Model | FireFox 2 |
| Category | Rivet Tools |
| Language | English |
To Next Page
