Gesipa PH 2000 - User Manual

Questions and Answers

T
timothypowellAug 9, 2025
Why is my Gesipa PH 2000 not setting blind rivets properly?
- M
  Margaret FoxAug 9, 2025
  If the blind rivet is not setting correctly with your Gesipa Rivet Tools, it could be due to several reasons. The jaws may be dirty; in this case, you should clean and oil the sliding surfaces. Alternatively, the jaws might be worn and need replacement. Finally, check that there is sufficient compressed air; refer to the operating pressure guidelines.
A
Amanda HoltAug 15, 2025
What to do if the spent mandrel is not conveyed automatically into the container of my Gesipa PH 2000?
- M
  Megan LyonsAug 15, 2025
  If the spent mandrel is not being conveyed automatically into the container with your Gesipa Rivet Tools, consider the following possibilities: a wrong nosepiece might be in use, so replace it according to the table provided. The nosepiece could also be worn, requiring replacement. Another cause might be the spent mandrel being jammed in the jaw housing, which means you should clean or replace the jaw mechanism. Also, check if the spent mandrel container is full and empty it if necessary. Finally, ensure the correct jaw pusher is being used and replace it according to the table.
C
colliermitchellAug 20, 2025
How to troubleshoot blind rivet setting issues with Gesipa PH 2000 Rivet Tools?
- D
  danielskarenAug 20, 2025
  If your Gesipa Rivet Tools are failing to set the blind rivet, the issue might stem from dirty jaws. You should clean and oil the sliding surfaces. Another potential cause is worn jaws, which would necessitate replacement. Also, ensure you're providing sufficient compressed air, checking the operating pressure guidelines.
K
kaitlyn17Aug 27, 2025
Why is the spent mandrel not automatically conveyed into the container in my Gesipa Rivet Tools?
- Y
  yatessherriAug 27, 2025
  The issue of spent mandrels not automatically conveying into the container of your Gesipa Rivet Tools can arise from several factors. A possible cause is using the wrong nosepiece, so you should replace it according to the specified table. Another reason could be a worn nosepiece, indicating it's time for a replacement. Additionally, the spent mandrel might be jammed in the jaw housing, suggesting you need to clean or replace the jaw mechanism.
J
jessicarushSep 1, 2025
What to do if Gesipa Rivet Tools don't set blind rivets?
- A
  Allen HoganSep 2, 2025
  If the blind rivet is not set by Gesipa Rivet Tools, make sure that the jaws are clean and oiled and not worn. Also, check the compressed air level.