EasyManua.ls Logo

Gesipa TAURUS 3 C - User Manual

Gesipa TAURUS 3 C
72 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GESIPA Blindniettechnik GmbH
Nordendstraße 13-39
64546 Mörfelden-Walldorf
Germany
T +49 (0) 6105 962 0
F +49 (0) 6105 962 287
info@gesipa.com
www.gesipa.com
Bedienungsanleitung TAURUS
®
C
mit Bediensoftware und Setzprozessüberwachung
Operating manual TAURUS
®
C
with operating software and setting process monitoring

Table of Contents

Questions and Answers

  • J
    Joseph BullockAug 11, 2025
    What to do if the spent mandrel is not evacuated from Gesipa Rivet Tools?
    • T
      Tamara KennedyAug 11, 2025
      If the spent mandrel is not being evacuated from your Gesipa Rivet Tools, first check if the spent mandrel container is full and empty it. Ensure you are using the correct nosepiece according to the tool's specifications and replace it if needed. Also, inspect the nosepiece for wear and replace if necessary. Finally, check the jaws for jammed mandrels; clean the jaws and jaw housing, oil the sliding surfaces, and replace the jaws if they are worn.
  • M
    Marvin JohnsonAug 26, 2025
    Why is the blind rivet not set with my Gesipa TAURUS 3 C?
    • M
      Matthew StoneAug 26, 2025
      If the blind rivet is not being set by your Gesipa Rivet Tools, several factors could be the cause. Start by cleaning and oiling the sliding surfaces of the jaws, as dirty jaws can prevent proper setting. If the jaws are worn, they will need to be replaced. Also, verify that the tool has sufficient working pressure. Finally, check if the tool stroke is too low and top up with hydraulic oil if necessary.

Gesipa TAURUS 3 C Specifications

General IconGeneral
BrandGesipa
ModelTAURUS 3 C
CategoryRivet Tools
LanguageEnglish

Related product manuals