Gesipa TAURUS 3 C - 1 Condition of Use; 2 Safety Notes; 3 Working Range

42
GB
1. Condition of use
This blind rivet setting tool may be used only to set blind rivets, as described in the operating
instructions.
The safety instructions MUST be followed!
2. Safety Notes
• UsethetoolONLYtosetblindrivets.
• Never overload the tool: Work within the stated performance parameters
• Never operate the tool without placing the blind rivet in the hole of the workpiece or the rivet could
come off the tool! Do not point the tool head towards yourself or anyone else!
• Thespent-mandrelcontainershouldalwaysbescrewedtightlyontothetoolwhilstinoperation.
• Regularly empty the spent mandrel container: Overloading may cause damage to the tool.
• Do not use the tool as a hammer.
• Regularly check the compressed air connections for ‹play› and leakage.
• Prior to maintenance and when not in use, always disconnect the tool from the compressed air supply..
• Safety glasses should always be worn when using the riveting tool. The use of any personal protective
clothing is always recommended.
• Do not exceed the air pressure limit of the tool.
• Whennotinuse,makesurethatthetoolcannotfalltotheoor.
• Repairsshouldbecarriedoutonlybyqualiedstaff.Whenindoubt,thetoolshouldbesentback(not
dismantled) to the supplier or to GESIPA
®
.
3. Working Range
Type of tool
TAURUS
®
1 C TAURUS
®
2 C TAURUS
®
3 C TAURUS
®
4 C
Standard blind rivet Ø
[mm]
2.4-3.2 up to 5 up to 6.4 up to 6.4
all materials
up to 4 Alu/
steel
up to 6 Alu/
steel
- up to 8 Alu