Gesipa TAURUS 3 C - 5 Equipment;Accessories; 6 Nosepiece Table

44
GB
6. Nosepiece table
Rivet Ø (mm) Rivet material Nosepiece Part No.
2.4 Alu 17/18 725 2075
3.2 CAP-Alu,CAP-Cu,PG-Alu/Stahl,PG-Cu/Niro,PG-Alu/Niro 17/20 725 2269
3 and 3.2 Alu,Cu,steel,stainlesssteel,Stinox,Alu/Alu,PG-Alu,PG-steel 17/22 725 5077
4 Alu,Cu,CAP-Alu,CAP-Cu 17/24 725 1583
4 Steel,-Alu/Alu,PG-Alu 17/27 725 2040
4 Stainlesssteel,Stinox,PG-steel 17/29 725 2059
4.8 and 5 Alu,CAP-Alu,CAP-Cu,PG-Alu 17/29 725 2059
4.8 and 5 Steel, Alu/Alu 17/32 725 2067
4.8 and 5 Stainlesssteel,Stinox,PG-steel 17/36 725 2083
6 Alu 17/36 725 2083
6 Steel 17/40 725 2560
6.4 Alu 17/40 725 2560
6.4 Steel, Alu/Alu 17/45 724 3065
8 Alu 17/45 724 3065
5. Equipment/Accessories
Type of tool
TAURUS
®
1 C TAURUS
®
2 C TAURUS
®
3/4 C
Nosepiece in working position 17/18 17/32 17/36
Nosepieces in tool base 17/20, 17/22
17/24, 17/27,
17/29
17/40, 17/45
1 wrench SW12/14
  
1 wrench SW14/17
  
1bottleofHydr.uid100ml
  
1oilllingcontainer
  
Power supply unit
  
Connector cable
  
BULB-TITE
®
Ø (mm) Rivet material Nosepiece Part No.
4 Al/Al 17/26 BT* 725 2202
5.2 Al/Al 17/32 BT* 725 2210
6.3 Al/Al, steel/steel, Monel/stainless steel 17/42 BT* 725 2229
7.7 Al/Al 17/48 BT* 725 2237