Why is the threaded mandrel not unthreading from my Gesipa Tools?
The threaded mandrel may not be unthreading because the setting stroke is too long or the threading-on time is too short. To resolve this, reduce the stroke. If necessary, unscrew with a hexagon screwdriver. Additionally, increase the threading-on period.
What to do if set rivet nut is loose with Gesipa Tools?
If the set rivet nut is loose, it is likely that the setting stroke is too short. To fix this, adjust to a larger stroke.
How to fix rivet nut not threading on Gesipa Tools?
If the rivet nut is not threading on, it could be due to a faulty rivet nut thread or a faulty mandrel thread. Try using a new rivet nut. If the issue persists, exchange the threaded mandrel and hold the rivet nut tightly when threading it out.
Adjusts the protrusion of the threaded mandrel for setting blind rivet nuts.
Sets the tool's stroke based on rivet nut size and material thickness.
Details the process of placing and setting blind rivet nuts using the tool.
Procedure for replacing the threaded mandrel on the setting tool.
Adjusts the time delay for the mandrel to retract after setting a rivet.
Diagnoses and resolves issues with rivet nuts failing to thread onto the mandrel.
Addresses causes and solutions for improperly set, loose rivet nuts.
Troubleshoots problems where the threaded mandrel fails to retract.
General| Brand | Gesipa |
|---|---|
| Model | GBM 95 |
| Category | Rivet Tools |
| Language | English |
To Next Page
