What to do if the red lamp indicates a fault while pressing the trigger button on Gesipa FireBird?
If the red lamp indicates a fault while pressing the trigger button, it might be because the blind rivet nut setting tool is not in the front end position. Try releasing the trigger button.
Why does the red lamp indicate fault during pulling operation on my Gesipa FireBird Power Tool?
The red lamp may indicate a fault during a pulling operation due to several reasons. It could be caused by an overload; ensure you are using the tool within the specified working range. Another cause might be the electronics overheating, in which case, allow the tool to cool down in the air. Finally, check the battery level, as a discharged battery can also trigger this fault; charge or replace it as needed.
What to do if the blind rivet nut does not screw on Gesipa Power Tool?
If the blind rivet nut does not screw on, there are several possible causes. The nut thread or the threaded mandrel might be defective, in this case use a new nut or change the threaded mandrel. Ensure the nut rests against the nosepiece, adapting the threaded mandrel length if necessary. If the battery switched off because it has been idle for longer than 21 days, place battery in the charger for 2 minutes. If the battery is discharged, charge it or replace if necessary. Ensure that while it is screwed on, hold the nut until the tool stops and keep switch K pressed until the tool stops.
Why is the set blind rivet nut loose on my Gesipa Power Tool?
A loose set blind rivet nut can occur if the setting stroke is too short; increase the setting stroke. Also, ensure that you keep switch K pressed until the automatic changeover and unscrewing are finished.
What to do if the threaded mandrel is not unscrewed from my Gesipa Power Tool?
If the threaded mandrel is not unscrewed, it could be due to an incorrectly adjusted setting stroke, so decrease the setting stroke. Another reason may be that the battery is discharged, so charge or replace the battery.
What does it mean if the red lamp indicates a fault after releasing the trigger button on my Gesipa FireBird?
If the red lamp indicates a fault after releasing the trigger button, it suggests that the front end position was not reached. To resolve this, screw together the mechanical parts.
Specifies the correct and intended use of the blind rivet nut setting tool for processing blind rivet nuts.
Provides essential safety rules to prevent electric shock, injuries, and fire hazards during operation.
Details the range of blind rivet nut sizes (M10 aluminium, M8 steel, M6 stainless steel) the tool can set.
Lists included equipment and available accessories like nosepieces, wrench, hanger, and battery charger.
Presents key technical specifications including weight, stroke, drive, force, noise, and vibration.
Details part numbers for different thread sizes (M3-M10) and their corresponding threaded mandrels and nosepieces.
Guides users on initial setup, including battery insertion, nosepiece selection, and mandrel length adjustment.
Explains the operation of screwing on and setting a blind rivet nut, including adjustments.
Provides technical specifications for the quick charger (type, voltage, current) and rechargeable battery (voltage, capacity).
Outlines crucial safety guidelines for operating the quick charger and handling the rechargeable battery.
Details the steps for charging the battery, including temperature limits and operation indicators.
Offers advice on optimizing battery life, recharging frequency, and proper storage conditions.
Covers guidelines for battery disposal and recycling in compliance with EU directives.
Lists causes and corrective measures when the blind rivet nut fails to screw onto the mandrel.
Provides solutions for issues where the set blind rivet nut remains loose.
Addresses problems with the threaded mandrel failing to unscrew after setting.
Explains the meaning of the red lamp indicator and corresponding corrective actions.
General| Brand | Gesipa |
|---|---|
| Model | FireBird |
| Category | Power Tool |
| Language | English |
To Next Page
