01
Introduction
Getac Camera is a geo-tagging camera program, which allows you to stamp geographical
information on photos as watermarks and embed such information into JPEG files as EXIF
2.2 metadata.
The installation source file is available to you either by downloading or through a storage media.
To install Getac Camera to your PS236:
- 01 -
02
Installing Getac Camera
NOTE:
●
●
For Getac Camera to run, the firmware version of your PS236 must be
G1.50.027.WWE/G1.51.027.WWE or later. You can ask your sales representative for
firmware updates. (To know the firmware version, tap Settings System
System Information Software Version ROM Image Version or see the
version number shown during the startup period.)
If you have problems starting the program, contact your sales representative for program
activation.
1.
2.
3.
Decompress the installation source file. You will get two files for two different
installation methods.
Use one of the methods to install the program.
Method 1: Connect your PS236 to your computer. Make sure that ActiveSync or
Mobile Device Center is working on your computer. Then, execute the file
PS236_Camera_1.0.X.X.exe (where X is a number). Your PS236 will respond and ask
for your action. Follow the onscreen instructions to complete the installation.
Method 2: Copy the file PS236_Camera_1.0.X.X.cab (where X is a number) to your
PS236. On your PS236, browse to the file and double tap it. Follow the onscreen
instructions to complete the installation.
After the installation, you will see the Getac Camera in the programs list.
To Next Page
Loading...
