Camera Mode Settings
The screen shows
the default settings.
- 05 -
To change camera settings, tap Menu while in
Camera Mode.
Tap the down arrow of the item you want to
adjust. In the pull-down menu, tap your choice.
When finished, tap Back and then Yes.
All changes (except for Mode) remain effective
until you change them again.
Menu Items
Mode Three choices for the shooting mode:
Normal
Descriptions
This is the default setting whenever the program is started.
This Five choices (Automatic, Sunshine, Cloudy, Fluorescence, and
Incandescence) from which you can select one that matches the current
light source.the default setting whenever the program is started.
Burst
Continuous shooting of 3 pictures.
Timer
5 second countdown before shooting.
Zoom Available choices depend on the current resolution setting.
Brightness Seven brightness levels.
x1
Available for all.
x2
Available under 640x480 resolution setting.
White Balance
On or Off.
Set to Off if you do not want the watermark to show in the picture. (This
does not affect the embedded EXIF 2.2 metadata.)
Watermark
Four choices (640x480, 1280x960, 1600x1200, and 2048x1536).
If the current zoom level is not valid for the resolution you have changed
to, the zoom level will be automatically adjusted. (See the descriptions of
the Zoom item for the relationship between resolutions and zoom levels.)
Resolution
Set to the frequency of the local electrical system (60Hz or 50Hz) for
flicker free shooting under electric light.
Flicker
On or Off.
Set to On for shooting in low light situations.
Night Mode
On or Off.
Set to On for the “backlight compensation” feature. This corrects the
exposure of subjects that are in front of a bright light source, therefore
resulting in clearer images.
BLC
On or Off.
Set to On to use the LED flashlight when taking pictures.
Flash
To Next Page
Loading...
Need help?
General
