GEZE ECdrive T2 Series - Safety-Conscious Working; Environmentally Conscious Working; Safety Instructions Related to Transportation and Storage; Qualification

ECdrive T2 Product family
5
Fundamental safety precautions
The product should be installed or incorporated in such a way that eortless access to the product is guaranteed
during any repairs and/or maintenance, and that any removal costs do not stand out of economic proportion
tothe value of the product.
2.3 Safety-conscious working
à Secure workplace against unauthorised entry.
à Watch the swivelling range of long system parts.
à Never carry out work with a high safety risk (e.g. installing the drive, cover or door leaf) while alone.
à Secure the cover/drive panels against falling.
à Secure non-xed components to prevent them falling.
à Use only the cables specied on the cable plan provided. Cables must be shielded in compliance with thewir-
ing diagram.
à Secure loose, internal drive cables with cable ties.
à Before working on the electrical system:
à Disconnect the drive from the 230 V mains and secure it against being switched back on again.
Check isolation from power supply.
à Disconnect the control unit from the 24 V rechargeable battery.
à Note that if an Uninterruptible Power Supply (UPS) is used, the system will still be supplied with voltage de-
spite the fact that the power supply is disconnected.
à Always use insulated wire-end ferrules for wire cores.
à Make sure of sucient lighting.
à Use safety glass.
à Attach safety stickers to glass door leaves.
à Danger of injury with opened drive. Hair, clothing, cables, etc. can be drawn in by rotating parts!
à Danger of injury caused by unsecured crushing, impact, drawing-in or shearing spots!
à Danger of injury due to glass breakage. Always only use safety glass!
à Danger of injury due to sharp edges on the drive and door leaf!
à Danger of injury during installation through freely moving parts!
2.4 Environmentally conscious working
à When disposing of the door system, separate the dierent materials and have them recycled.
à Do not dispose of batteries and rechargeable batteries with household waste.
à Comply with the statutory regulations when disposing of the door system and the batteries/rechargeable batteries.
2.5 Safety instructions related to transportation and storage
à The door system and its parts are not designed for hard impacts or for falls from high areas.
X
Do not throw, do not drop.
à Storage temperatures under –30 °C and above +60 °C can result in damage to the device.
à Protect against humidity.
à Use special glass transport devices (e.g. A-frames) for transporting glass.
à Separate several panes on a frame or during storage using intermediate layers (e.g. cork pads, paper or plastic cords).
à Always store glass in a vertical position on level and load-bearing ground. Use suitable material as a support
(e.g. wooden slats).
à In the case of insulated glass, make sure that it is placed ush across the entire element thickness on at least
2supports.
à During storage and support, safety devices must not cause any damage to the glass or edge seal of insulated
glass and must be attached at on the pane surface.
à Dry, well ventilated, closed, weather-proof and UV-protected rooms are suitable as storage areas.
2.6 Qualication
Observe country-specic regulations!
Applicable in Germany:
Companies that handle the pre-mounting of sliding door drives for escape routes must be licensed by the testing
institution that issued the type approval certicate as an expanded production facility.