GEZE GC 339 Manual

Safety GC 339
4
Product liability
In compliance with the liability of the manufacturer for his products as
dened in the German “Product Liability Act”, compliance with the infor-
mation contained in this brochure (product information and intended use,
misuse, product performance, product maintenance, obligations to provide
information and instructions) must be ensured. Failure to comply releases
the manufacturer from his statutory liability.
1 Safety
1.1 Intended use
The safety sensor GC339 may only be used to protect automatic sliding
doors and curved sliding doors with GEZE drives. The minimum object size
corresponds to the reference object CA according to DIN 18650 or 16005
both upright and lying down. The sensor can be used to secure automatic
sliding doors against impact and trapping of the human body.
GC339
1.2 Safety notices
à The prescribed mounting, maintenance and repair work must be per-
formed by personnel authorised by GEZE. Any attempts at repairs by
unauthorised personnel cancel the factory guarantee.
à The device may only be operated with safety extra-low voltage (SELV)
with electrically protective separation.
à The country-specic laws and regulations are to be observed during
safety-related tests.
à Make sure that the cover of the drive is tted correctly and earthed.
à If unauthorised changes are made to the system, GEZE cannot be held
liable in any way whatsoever for any resulting damage, and the approval
for use on escape and rescue routes ceases.
à GEZE does not accept any warranty for combinations with third-party
products.
à Only original GEZE parts may be used for repair and maintenance work.
à Observe the latest versions of directives, standards and country-specic
regulations, in particular:
à ASR A1.7 “Doors and gates”
à DIN 18650 “Building hardware - Powered pedestrian doors”

GEZE GC 339 Specifications

General

Brand	GEZE
Model	GC 339
Category	Security Sensors
Language	English