GEZE GC 339+ - Safety; Intended Use; Safety Notes

5
SafetyGC 339+
1 Safety
1.1 Intended use
The GC339+ safety sensor may only be used to protect automatic sliding
doors and curved sliding doors with GEZE drives. The minimum object size
corresponds to the reference object CA according to DIN 18650 or 16005
both upright and lying down. The sensor can be used to secure automatic
sliding doors against impact and trapping of the human body.
GC339
1.2 Safety notes
à The prescribed mounting, maintenance and repair work must be per-
formed by personnel authorised by GEZE. Any attempts at repairs by
unauthorised personnel cancel the factory guarantee.
à The device may only be operated with safety extra-low voltage (SELV)
with electrically protective separation.
à The country-specic laws and regulations are to be observed during
safety-related tests.
à Make sure that the cover of the drive is tted correctly and earthed.
à If unauthorised changes are made to the system, GEZE cannot be held li-
able in any way whatsoever for any resulting damage, and the statement
of approval for use in escape and rescue routes is no longer valid.
à GEZE does not accept any warranty for combinations with third-party
products.
à Only original GEZE parts may be used for repair and maintenance work.
à Observe the latest versions of guidelines, standards and country-specic
regulations, in particular:
à ASR A1.7 “Doors and gates”
à DIN 18650 “Building hardware – Powered pedestrian doors”
à DIN EN 16005 “Power operated pedestrian doorsets – Safety in use –
Requirements and test methods”
à Accident-prevention regulations, especially BGV A1 “General regula-
tions” and BGV A2 “Electrical installations and equipment”.