What to do if the pilot light won't light on my GGMgastro Grill?
If the pilot light on your GGMgastro Grill won't light, there could be a couple of reasons. First, ensure the gas isolation valve is turned on and that the gas bottle isn't empty. If the gas supply is fine, the pilot injector might be blocked, in which case you should call a service provider.
Why does the pilot light go out when I release the gas control knob on my GGMgastro GLGK46-E?
The pilot light might be going out when you release the gas control knob on your GGMgastro Grill because you're releasing the knob before the thermocouple has heated up sufficiently. Hold the knob in for at least 20 seconds after the pilot light ignites. Other potential causes, that require calling a service provider, include a pilot flame that's too small, gas pressure that's too low, a partially blocked pilot injector, or a faulty thermocouple.
Read manual, keep for reference, install and use safely by trained personnel. Comply with regulations.
Operate safely, never leave unattended when hot. Turn off valve during malfunction and call service.
Application for grilling/simmering in kitchens. Exterior is stainless steel with gas burners and safety valves.
Manufacturer not liable for installation errors. Installation must comply with local gas, health and safety requirements.
Install in a well-ventilated area, possibly under a vent hood, to ensure complete exhaust of burnt gases.
Use non-combustible materials near flammable or heat-sensitive walls to prevent damage.
Check gas family setting, storage conditions, transport carefully, and unpack all materials.
Appliance designed for natural/liquid gas. Refer to table for country-specific category.
Ensure correct gas type and adequate supply pressure. Check for leaks after installation using a manometer.
Verify gas technical specs, start appliance, check leaks, flame stability, and pilot flame operation.
Train personnel on operation. Locate and understand the rating plate for appliance specifications.
Convert appliance between gas types by changing main and pilot burner nozzles as per specifications.
Access air ratio device by removing the control panel and adjust based on burner flame.
Procedure to replace pilot flame nozzle involves removing thermocouple and gas pipe.
Perform checks including starting, leak testing, flame stability, and pilot flame operation.
Clean the appliance thoroughly before first use, removing all packaging and adhesive films.
Instructions on how to turn burners on and off using the control knob and pulse igniter.
Turn off appliance and gas supply before cleaning. Use appropriate detergents for stainless steel.
Qualified personnel must perform annual checks on controls, safety devices, and burner combustion.
Guide to common problems like pilot not lighting or going out, and main burner not lighting.
To Next Page
General