73
4.4 ENERGYPAK-BATTERY
BATTERY CARRIER BATTERY CASING
DISASSEMBLE:
1
To remove the battery casing: Please note that this operation could cause
some (minor) damage to the battery case. If there is any more than super-
ficial damage, the case should be replaced. Remove the 4 screws on the
corners on the bottom of the battery.
2
Use a small and thin flathead screwdriver as a lever between the con-
nector and the casing, to create a small gap.
3
Place a tire-lever in the gap as pictured, and apply some force to open
the gap a bit further.
4
Place another tire-lever next to the first, and push it over to pop the bat-
tery open.
5
Repeat along the length of the battery, step by step, until one side of the
case is completely released.
To Next Page
