BIOS Setup- 33 -
English
Spread Spectrum Modulated
Disabled Disable clock spread spectrum.
Enabled Enable clock spread spectrum.(Default value)
CPU Host Clock Control
Note: If system hangs up before enter CMOS setup utility, wait for 20 sec for times out reboot . When
time out occur, system will reset and run at CPU default Host clock at next boot.
Disable Disable CPU Host Clock Control.(Default value)
Enable Enable CPU Host Clock Control.
CPU Host Frequency (MHz)
100 Set CPU Host Clock to 100MHz~132MHz.
133 Set CPU Host Clock to 133MHz~165MHz.
166 Set CPU Host Clock to 166MHz~200MHz.
200 Set CPU Host Clock to 200MHz~254MHz.
PCI/AGP Frequency (MHz)
The values depend on CPU Host Frequency(Mhz) .
FDRAM Clock (MHz)
Please set DRAM Clock according to your requirement. (Default value: Auto)
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to "133-DDR266". If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to "166-DDR333". If you use DDR400
DRAM module, please set "DRAM Clock(MHz)" to "200-DDR400".
Incorrect using it may cause your system broken. For power End-User use only!
CPU OverVoltage Control
Increase CPU voltage may get stable for Over_Clock. But it may damage to CPU when enable this
feature.
Auto Supply voltage as CPU reguired. (Default value)
+5% / +7.5% / +10% Increase voltage range as user selected.
AGP OverVoltage Control
Increase AGP voltage may get stable for Over_Clock. But it may damage to AGP Card when
enable this feature.
Auto Supply voltage as AGP Card reguired. (Default value)
+0.1V ~ +0.3V Set AGP voltage from 1.6V~1.8V.
DIMM OverVoltage Control
I ncrease DRAM voltage may get stable for Over_Clock. But it may damage to DRAM module when
enable this feature.
Auto Supply voltage as DRAM module reguired. (Default value)
+0.1V ~ +0.3V Set DIMM voltage from 2.6V~2.8V.
To Next Page
Loading...
