Gigabyte G1.Sniper M3 - Multi-GPU Configuration

- 19 - Hardware Installation
1-6 Setting up AMD CrossFireX
™
/NVIDIA SLI Conguration
(Note) The bridge connector(s) may be needed or not depending on your graphics cards.
Procedure and driver screen for enabling CrossFireX/SLI technology may differ by graphics cards and
driver version. Refer to the manual that came with your graphics cards for more information about
enabling CrossFireX/SLI technology.
C-2. To Enable SLI Function
After installing the graphics card driver in the operating system, go
to the NVIDIA Control Panel. Browse to the Set SLI and Physx
Conguration screen and ensure Maximize 3D performance is
enabled.
A. System Requirements
Windows 7 operating system -
A CrossFireX/SLI-supported motherboard with two PCI Express x16 slots and correct driver -
Two CrossFireX/SLI-ready graphics cards of identical brand and chip and correct driver -
CrossFireX -
(Note)
/SLI bridge connectors
A power supply with sufcient power is recommended (Refer to the manual of your graphics cards for the -
power requirement)
B. Connecting the Graphics Cards
Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and install two CrossFireX/SLI graphics cards on the
PCIEX16 and PCIEX8 slots.
Step 2:
Insert the CrossFireX
(Note)
/SLI bridge connectors in the CrossFireX/SLI gold edge connectors on top of the
cards.
Step 3:
Plug the display cable into the graphics card on the PCIEX16 slot.
C. Conguring the Graphics Card Driver
C-1. To Enable CrossFireX Function
After installing the graphics card driver in the operating system,
go to the Catalyst Control Center. Browse to Performance\AMD
CrossFireX™ Conguration and ensure the Enable CrossFireX™
check box is selected. and click Apply.