Gigabyte G262-IR0 - Installing the Memory; Memory Population Table

- 29 -
System Hardware Installation
3-5-2 Installing the Memory
3-5-3 Memory Population Table
Type
Ranks Per DIMM
and Data Width
DIMM Capacity (GB)
Speed (MT/s); Voltage (V);
Slots per Channel(SPC) and DIMM per Channel
(DPC)
DRAM Density 1DPC 2DPC
8Gb 16Gb 1.2V 1.2V
RDIMM
SRx8 8GB 16GB
3200
SRx4 16GB 32GB
DRx8 16GB 32GB
DRx4 32GB 64GB
RDIMM 3DS (4R/8R) x 4
2H-64GB 2H-128GB
4H-128GB 4H-256GB
LRDIMM QRx4 64GB 128GB
LRDIMM 3DS
QRx4 2H-64GB 2H-128GB
(4R/8R) x 4 4H-128GB 4H-256GB
Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR4 DIMMs on this motherboard.
Follow these instructions to install the Memory:
1. Insert the DIMM memory module vertically into the DIMM slot, and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.
1
2
2
NOTE!
l
DIMM must be populated in sequential alphabetic order, starting with DIMM0.
l
When only one DIMM is used, it must be populated in memory slot DIMM0.