Gigabyte GA-8I915P Dual Graphic - Battery and Dip Switch

Hardware Installation- 29 -
English
19) BAT(Battery)
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
If you want to erase CMOS...
1.Turn OFF the computer and unplug the power cord.
2.Remove the battery, wait for 30 second.
3.Re-install the battery.
4.Plug the power cord and turn ON the computer.
20) SW1 (Dual Graphic Dip Switch)
If you want to use the PCIE_1 slot, set all of
the four pins to OFF.
1
2
3
4
1
2
3
4
If you want to use the PCIE_16_2 slot or
enable the Dual Graphic fuction, set all of them
to ON