Gigabyte GA-945GCM-S2L - Standard CMOS Features Configuration

2-3 Standard CMOS Features
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Standard CMOS Features
Dale (mm:dd:yy)
•vU Aug 6 2007
Item Help
Time (hh:mm:ss)
10:31:24 Menu Level*
• IDE Channel 0 Master
• IDE Channel 0 Slave
• IDE Channel 2 Master
• IDE Channel 2 Slave
• IDE Channel 3 Master
• IDE Channel 3 Slave
[None]
[None]
[None]
[None]
[None|
[None)
Drive A
Floppy 3 Mode Support
[1.44M, 3.5"]
| Disabled]
Halt On
[AH, But Keyboard)
T•!.-»«-: Move Enter: Select
F5: Previous Values
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
ESC: Exit Fl: General Help
F7: Optimized Defaults
^ Date
Sets the system date. The date format is week (read-only), month, date and year. Select the
desired field and use the up arrow or down arrow key to set the date.
^ Time
Sets the system time. For example, 1 p.m. is 13:0:0. Select the desired field and use the up arrow
or down arrow key to set the time.
^ IDE Channel 0 Master/Slave
•• IDE HDD Auto-Detection
Press <Enter> to autodetect the parameters of the IDE/SATA device on this channel.
•• IDE Channel 0 Master/Slave
Configure your IDE/SATA devices by using one of the three methods below:
• Auto Lets BIOS automatically detect IDE/SATA devices during the POST. (Default)
• None If no IDE/SATA devices are used, set this item to None so the system will
skip the detection of the device during the POST for faster system startup.
• Manual Allows you to manually enter the specifications of the hard drive when the
hard drive access mode is set to CHS.
•• Access Mode Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large.
с IDE Channel 2,3 Master/Slave
•• IDE Auto-Detection
Press <Enter> to autodetect the parameters of the IDE/SATA device on this channel.
•• Extended IDE Drive
Configure your IDE/SATA devices by using one of the two methods below:
• Auto Lets BIOS automatically detect IDE/SATA devices during the POST. (Default)
• None If no IDE/SATA devices are used, set this item to None so the system will
skip the detection of the device during the POST for faster system startup.
•• Access Mode Sets the hard drive access mode. Options are: Auto (default), Large.
- 35 -
BIOS Setup